PRSRXDIS=X0, TXPOSTPONE=X0, PRSCLR=RXSEARCH, PRSFORCETX=X0, ACTIVEPOL=X0, PRSMODE=DIRECT, LNAENPOL=X0, TXAFTERRX=X0, PAENPOL=X0
No Description
| FORCEDISABLE | Force Radio Disable |
| PRSTXEN | PRS TX Enable |
| TXAFTERRX | TX After RX 0 (X0): TX will not be started automatically. 1 (X1): A transition to TX is automatically started when a received frame is accepted by the FRC. |
| PRSMODE | PRS RXEN Mode 0 (DIRECT): The PRS signal is used directly 1 (PULSE): The PRS signal is used as an RX enable pulse |
| PRSCLR | PRS RXEN Clear 0 (RXSEARCH): The PRS RXEN signal is cleared when the RSM state enters RXSEARCH 1 (PRSCH): The Selected PRS channel in PRSCLRSEL is used as a disable pulse |
| TXPOSTPONE | TX Postpone 0 (X0): In the TX state transmit data is output. 1 (X1): In the TX state an unmodulated carrier is output until this bit is cleared. |
| ACTIVEPOL | ACTIVE signal polarity 0 (X0): Active low 1 (X1): Active high |
| PAENPOL | PAEN signal polarity 0 (X0): Active low 1 (X1): Active high |
| LNAENPOL | LNAEN signal polarity 0 (X0): Active low 1 (X1): Active high |
| PRSRXDIS | PRS RX Disable 0 (X0): PRS will not disable RX 1 (X1): The channel selected by PRSRXDISSEL will generate a disable RX pulse |
| PRSFORCETX | PRS Force RX 0 (X0): PRS will not force TX 1 (X1): The channel selected by PRSFORCETXSEL will generate a force TX pulse |
| SEQRESET | SEQ reset |
| EXITSHUTDOWNDIS | Exit SHUTDOWN state Disable |
| CPUWAITDIS | SEQ CPU Wait Disable |
| SEQCLKDIS | SEQ Clk Disable |
| RXOFDIS | Switch to RXOVERFLOW Disable |